Furuno set up
Submitted by fishfish on Tue, 2013-04-16 21:08
Hi all , a question for all the furuno users out there and specifically fcv 627 or it possibly doesn't matter.
What settings are you guys using for your clutter and colour erase ?? These two are the ones I'm having problems with everything else is sweet .
Im basically running a small percentage of each basically just to clear the screen up but I noticed that I can run a fair amount of gain approx 8-9 but varies .
Also does anyone use the interference function or is it just for exactly that electrical interference and if none present dont run it ???
Cheers for the help fishfish
mr_meks
Posts: 189
Date Joined: 11/02/11
I get a bit of interference
I get a bit of interference in the form of short vertical lines all over my 620's screen if I run my lowrance at the same time (83 khz). The interference function helps clear that up.
Ryan Thipthorp (not verified)
Posts: 16
Date Joined: 01/01/70
FCV-620 Settings!
These are my FCV-620 Furuno settings I use;
What settings are you guys using for your clutter?
15%
Colour erase ?
20%
gain approx 8-9 but varies?
Sounds too high, should be no higher than 5-6
Try having all settings to manual!!!!
fishfish
Posts: 307
Date Joined: 01/09/09
Settings
Thanks Meks that's what I suspected I think I have it set on Low so I'll turn it off and see .
And Ryan the gain also seemed high as well , going off sounder screen shots I've seen posted but the screen looks clean and defined so I'm not sure and I check those percentages but those numbers sound familiar , also all settings are on manual .
Thanks for the help cheers fishfish